Since these maladies, by their very nature have a notable amount of tissue built up, it will take your body some time (after the virus is gone) to reduce the tissue mass.
Warts can take up to a month to fully disappear. Prepare the wart for treatment by removing wart tissue with a dissolving product and soften the area by soaking or warm compress. These steps will increase the depth of penetration for the DermaSeptic and allows more effective reduction of the virus with each treatment.
Odorless: yes
Directions: Before you begin treatment, clean the area of skin using soap and water.
Gently clean the silver tip using the emery board only. Apply a thin, even layer of silver conductive gel to the silver tip. Also apply a small dab of silver conductive gel to the finger you will use to hold the unit. Hold the case so that the finger with the conductive gel presses firmly against the stainless steel contact plate.
Press the silver tip to the area you wish to treat. The green LED indicator will flash when the device is activated and working. You will not feel any sensation from the unit even though it is operating effectively.
Each individual is unique and you will determine the best treatment routine for your own situation. In some situations, you may want to test slightly longer treatment times for a more aggressive treatment. You may also use shorter treatment times if that works well for you. DermaSeptic is very safe for a wide variety of treatment times.
10 minutes twice a day until the tenderness or growth stops.
DermaSeptic requires only that the silver tip and stainless contact plate be kept clean. The silver tip should be lightly abraded with the emery board provided. (DO NOT use steel wool or any emery board that contains other than flint or silica as other materials will interfere with the silver’s anti-microbial properties.) The stainless steel contact plate can usually be kept clean with a damp towel.
Do not submerge the unit in water!
The battery will last up to a year. Steps to replace the battery:
Unscrew the silver tip by hand.
Unscrew the stainless contact plate.
Open the case.
Lift the circuit board out of the case by prying it with a small screwdriver. The circuit board is sturdy but use normal care.
Slip the old battery out of its holder and slip the new one in.
The battery type is an inexpensive 3v Lithium Cell CR2032. Most stores that sell batteries have them and they can also be ordered from Dermaseptic.
